DRAIN PARTS WORKSHEET
Outside Diameter (O.D.) - Measure from rim to rim. Simply catch the hook of your tape measure on the rim, pull tight, and measure 180° directly across to the outisde edge of the opposite rim.
Bolt Hole to Bolt Hole - Most clamp rings will have either 3, 4, or 5 bolt holes (OMG, UFlow clamp rings have 6 bolt holes). Ensure that your measurement(s) are from the center of one bolt hole to the center of the next bolt hole. For each size clamp ring you will need the following measurements:
- 3 Bolt Hole Ring=120°
- 4 Bolt Hole Ring=180° & 90°
- 5 Bolt Hole Ring=72°
Outside Diameter (O.D.) - Turn the dome upside down and catch the edge of your tape measure on the dome's outside edge. Measure 180° across to the opposite outside edge. If there are locking tabs on your dome, do not include them in your measurement.
Height - From a flat surface, simply measure from the base of the dome to the highest point. Do not include any standoff tabs on the bottom of the dome.
Used in flat roofs of any construction where a medium sized drain is required. Flashing clamp holds flashing and roofing material without puncturing. Low profile dome protects sump and intercepts debris.
PLEASE NOTE WHEN CHOOSING OPTIONS BELOW, If you choose to add the sump receiver and under deck clamp, you DO NOT NEED the top mount deck plate. If you choose the top mount deck plate, you DO NOT NEED the sump receiver and under deck clamp. Please call us if you have any questions.
Price as Configured
Please note, the Top Mount Deck Plate replaces the underdeck clamp & roof-sump receiver by combining them into one easy to install part. It should be ordered in lieu of these two items.
1310 Spec Sheet
1310 Line Drawing
Regularly Furnished:Duco Cast Iron Body with Combined Flashing Clamp and Gravel Stop with Polyethylene Dome.